Ameritas Dental Network Is a half minutes of molding the material for the first seconds or so remove it and examine the tray and start where the tray has actually perforated the Ameritas Dental Network .
That you placed um any place that where the trait shows through you’re gonna presume that your trays going to be pushing on the tissues and you need to relieve it and you do it simply with just a carbide burr and just grind .
Whatever areas present as show through you can also create relief in the tray if you want to as well here’s an example if you look at the maxillary tray you can see we’re overextended in the tuberose on the right there’s an show through on .
The left on the mandibular tray you can see we’re overextended in the anterior leg wheel area we’re overextended in the mid portion of the alveolar Ridge and in the Ticketmaster notch just simply take that car Viper and grind those spots liberally then.
What you’re gonna do is you’re gonna take aqua isl ultra lb fast set light viscosity and you’re gonna place that into the tray and we’re gonna make our final impression just the same way just put a light coating over the tray cover the middle place it in the mouth and hold it there doing boredom old emotions.
We will loop moving it after two and a half minutes of the time you’re done this is your final impression and we’re probably at maybe between ten and fifteen minutes into that thirty minutes set but segment .
if you see any defects or if you want to increase the fidelity of the impression you can use aqua ail ultra XV extra light viscosity and apply that in it’s very water like put it in the mouth have them go through border molding motions.